No Matches
STM32 Nucleo-G431RB

Support for the STM32 Nucleo-G431RB. More...

Detailed Description

Support for the STM32 Nucleo-G431RB.


The Nucleo-G431RB is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32G431RB microcontroller with 32KiB of RAM and 128KiB of Flash.

Flashing the device

Flashing the Board Using OpenOCD

The ST Nucleo-G431RB board includes an on-board ST-LINK V3 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing

make BOARD=nucleo-g431rb flash

and debug via GDB by simply typing

make BOARD=nucleo-g431rb debug

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-g431re PROGRAMMER=cpy2remed flash
This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.

Supported Toolchains

For using the ST Nucleo-G431RB board we recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.


file  periph_conf.h
 Peripheral MCU configuration for the nucleo-g431rb board.