Loading...
Searching...
No Matches
STM32 Nucleo-L152RE

Support for the STM32 Nucleo-L152RE. More...

Detailed Description

Support for the STM32 Nucleo-L152RE.

Overview

The Nucleo-L152RE is a board from ST's Nucleo family supporting a ARM Cortex-M3 STM32L152RE microcontroller with 80KiB of RAM and 512KiB of Flash.

Hardware

Nucleo64 L152RE

Pinout

Pinout for the nucleo-l152re

MCU

MCU STM32L152RE
Family ARM Cortex-M3
Vendor ST Microelectronics
RAM 80KiB
Flash 512KiB
EEPROM 16KB
Frequency up to 32MHz
FPU no
Timers 12 (8x 16-bit, 1x 32-bit [TIM5], 1x Systick, 2x watchdog)
ADCs 1x 12-bit (21 channels)
UARTs 5
SPIs 3-8 (UARTs can be configured as SPIs)
I2Cs 2
Vcc 1.65V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

User Interface

2 Buttons:

NAME USER RESET
Pin PC13 (IN) NRST

1 LED:

NAME LD2
Color green
Pin PA5

Supported Toolchains

For using the Nucleo-L152RE board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Flashing the device

Flashing the Board Using OpenOCD

Please use an OpenOCD version checked out after Jan. 26th 2015. Building instructions can be found here.

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-l152re PROGRAMMER=cpy2remed flash
Note
This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.

Using UART

Using the UART isn't too stable right now. For some using the USB interface just works, others have to connect the USB interface to a active USB hub and others again can only transmit over the USB interface and receive using an external UART adapter.

Connecting an external UART adapter

  1. connect your usb tty to the st-link header as marked st-link-header
  2. done

Files

file  periph_conf.h
 Peripheral MCU configuration for the nucleo-l152re board.