Loading...
Searching...
No Matches
STM32 Nucleo-F446RE

Support for the STM32 Nucleo-F446RE. More...

Detailed Description

Support for the STM32 Nucleo-F446RE.

Overview

The Nucleo-F446RE is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F446RE microcontroller with 128KiB of RAM and 512KiB of Flash.

Hardware

Nucleo64 F446RE

Pinout

Pinout for the nucleo-f446re

MCU

MCU STM32F446RE
Family ARM Cortex-M4
Vendor ST Microelectronics
RAM 128KiB
Flash 512KiB
Frequency up to 180MHz
FPU yes
Timers 17 (2x watchdog, 1 SysTick, 12x 16-bit, 2x 32-bit [TIM2])
ADCs 3x 12-bit (16 channels)
UARTs 6
SPIs 4
I2Cs 4
RTC 1
CAN 2
USB 1
Vcc 1.8V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

Implementation Status

Device ID Supported Comments
MCU STM32F446RE partly Energy saving modes not fully utilized
Low-level driver GPIO yes
PWM yes (9 pins available)
UART 3 UARTs USART2 via STLink/USB or D0(RX)/D1(TX), USART3 on PC11(RX)/PC10(TX) and USART1 on PA10(RX)/PA9(TX)
I2C one I2C
SPI one SPI
USB no
Timer one 32 bit timer

Flashing the device

Flashing the Board Using OpenOCD

The ST Nucleo-F446RE board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing

make BOARD=nucleo-f446re flash

and debug via GDB by simply typing

make BOARD=nucleo-f446re debug

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-f446re PROGRAMMER=cpy2remed flash
Note
This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.

Supported Toolchains

For using the ST Nucleo-F446RE board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Files

file  periph_conf.h