Loading...
Searching...
No Matches
STM32 Nucleo-F303RE

Support for the STM32 Nucleo-F303RE. More...

Detailed Description

Support for the STM32 Nucleo-F303RE.

Overview

The Nucleo-F303RE is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F303RE microcontroller with 64KiB of RAM and 512KiB of Flash.

Hardware

Nucleo64 F303RE nucleo-f303 pinout

Pinout

Pinout for the nucleo-f303re

MCU

MCU STM32F303RE
Family ARM Cortex-M4
Vendor ST Microelectronics
RAM 64KiB
Flash 512KiB
Frequency up to 72MHz
FPU yes
Timers 13 (9x 16-bit, 1x 32-bit [TIM2], 1x Systick, 2x watchdog)
ADCs 4x 12-bit (22 channels)
UARTs 5
SPIs 4
I2Cs 3
RTC 1
CAN 1
USB 1
Vcc 2.0V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

Implementation Status

Device ID Supported Comments
MCU STM32F303RE partly Energy saving modes not fully utilized
Low-level driver GPIO yes
PWM one PWM
UART three UART
I2C two I2C
SPI two SPI
USB no
Timer one 32 timer

Flashing the device

Flashing the Board Using OpenOCD

The ST Nucleo-F303RE board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing.

BOARD=nucleo-f303re make flash

and debug via GDB by simply typing

BOARD=nucleo-f303re make debug

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-f303re PROGRAMMER=cpy2remed flash
Note
This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.

Supported Toolchains

For using the ST Nucleo-F303RE board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Files

file  periph_conf.h
 Peripheral MCU configuration for the nucleo-f303re board.