Loading...
Searching...
No Matches
ESP32-Ethernet-Kit V1.2 Board

Support for for Espressif ESP32-Ethernet-Kit V1.2.

Support for for Espressif ESP32-Ethernet-Kit V1.2.

Author
Gunar Schorcht gunar.nosp@m.@sch.nosp@m.orcht.nosp@m..net
Erik Ekman eekma.nosp@m.n@go.nosp@m.ogle..nosp@m.com

Espressif ESP32-Ethernet-Kit v1.2

Table of Contents

  1. Overview
  2. Hardware
    1. Board Configuration
    2. Board Pinout
  3. Other Documentation Resources

Overview

The Espressif ESP32-Ethernet-Kit is a development board that uses the ESP32-WROVER-E module. Most important features of the board are

Furthermore, some GPIOs are broken out for extension. The USB bridge based on FDI FT2232HL provides a JTAG interface for OCD debugging through the USB interface. For flashing and debugging the board, see ESP32-Ethernet-Kit common board documentation.

ESP32-Ethernet-Kit V1.2

Back to table of contents

Hardware

This section describes

Back to table of contents

Board Configuration

ESP32-Ethernet-Kit v1.2 has the following on-board components

For detailed information about the configuration of ESP32 boards, see section Peripherals in RIOT-OS on ESP32 SoC Series Boards.

Note
Only a few GPIOs are broken out and available for external hardware on ESP32-Ethernet-Kit boards. Which GPIOs are available as peripherals depends on used modules.
Function GPIOs Remarks Configuration
BTN0 GPIO0 not available if esp_eth is used
ADC GPIO34, GPIO35, GPIO36, GPIO39 ADC Channels
DAC - DAC Channels
PWM_DEV(0) GPIO2, GPIO4 PWM Channels
I2C_DEV(0):SDA GPIO32 I2C Interfaces
I2C_DEV(0):SCL GPIO33 I2C Interfaces
SPI_DEV(0):CLK GPIO14 HSPI is used SPI Interfaces
SPI_DEV(0):MISO GPIO12 HSPI is used SPI Interfaces
SPI_DEV(0):MOSI GPIO13 HSPI is used SPI Interfaces
SPI_DEV(0):CS0 GPIO15 HSPI is used SPI Interfaces
UART_DEV(0):TxD GPIO1 Console (configuration is fixed) UART interfaces
UART_DEV(0):RxD GPIO3 Console (configuration is fixed) UART interfaces


Note
SPI_DEV(0) is not available if module esp_jtag is used. For the SPI_DEV(0) pins to work properly, the function switches (DIP switches) for the JTAG signals must be set to OFF.

Back to table of contents

Board Pinout

The board schematic can be found here.

By default, only 4 bidirectional GPIO pins are unused: GPIO2, GPIO4, GPIO32, GPIO33. The suggested configuration is for PWM and I2C, but they can also be used for SPI or another serial port. By disabling the JTAG interface on the board, another 4 GPIOs can be made available (GPIO12, GPIO13, GPIO14, GPIO15).

Back to table of contents

Other Documentation Resources

There is a comprehensive Getting Started Guide for the ESP32-Ethernet-Kit with a lot information about hardware configuration.

Back to table of contents