Loading...
Searching...
No Matches
STM32 Nucleo-L432KC

Support for the STM32 Nucleo-L432KC. More...

Detailed Description

Support for the STM32 Nucleo-L432KC.

Overview

The Nucleo-L432KC is a board from ST's Nucleo family supporting ARM Cortex-M4 STM32L432KCU6 microcontroller with 64KiB of RAM and 256KiB of Flash.

Pinout

Pinout for the Nucleo-L432KC (from STM user manual, UM1956, https://www.st.com/resource/en/user_manual/um1956-stm32-nucleo32-boards-mb1180-stmicroelectronics.pdf, page 32)

MCU

MCU STM32L432KC
Family ARM Cortex-M4
Vendor ST Microelectronics
RAM 64KiB
Flash 256KiB
Frequency up to 80MHz
FPU yes
Timers 11 (7x 16-bit, 1x 32, 1x Systick, 2x Watchdog)
ADC 1x 12-bit (10 channels)
UARTs 3 (two USARTs and one Low-Power UART)
SPIs 2
CANs 1
RTC 1
I2Cs 2
Vcc ToDo1.7V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-l432kc PROGRAMMER=cpy2remed flash
Note
This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates can be found on this STM webpage.

Files

file  periph_conf.h
 Peripheral MCU configuration for the nucleo-l432kc board.