STM32 Nucleo-L496ZG

Support for the STM32 Nucleo-l496zg. More...

Detailed Description

Support for the STM32 Nucleo-l496zg.

Overview

The Nucleo-L496ZG is a board from ST's Nucleo family supporting ARM Cortex-M4 STM32L496ZG ultra-low-pawer microcontroller with 320KiB of RAM and 1 MiB of Flash.

Pinout

Pinout for the Nucleo-L496ZG (from STM user manual, UM2179, https://www.st.com/resource/en/user_manual/um2179-stm32-nucleo144-boards-mb1312-stmicroelectronics.pdf, page 31)

MCU

MCU	STM32L496ZG
Family	ARM Cortex-M4F
Vendor	ST Microelectronics
RAM	320KiB
Flash	1MiB
Frequency	up to 80MHz
FPU	yes
Timers	16 (2x watchdog, 1 SysTick, 11x 16-bit, 2x 32-bit)
ADCs	3x 12-bit (24 channels
UARTs	6 (5x UARTs and one Low-Power UART)
SPIs	3
I2Cs	4
RTC	1
CAN	2
Datasheet	Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-l496zg PROGRAMMER=cpy2remed flash

Note

This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates can be found on [this STM webpage](https://www.st.com/en/development-tools/stsw-link007.html

Files
file	periph_conf.h
	Peripheral MCU configuration for the nucleo144-l496 board.