Board specific definitions for the STK3200 starter kit. More...
Board specific definitions for the STK3200 starter kit.
Definition in file board.h.
#include "cpu.h"#include "periph_conf.h"#include "periph/adc.h"#include "periph/gpio.h"#include "periph/spi.h"
Include dependency graph for board.h: This graph shows which files directly or indirectly include this file:Go to the source code of this file.
Xtimer configuration | |
The timer runs at 250 kHz. | |
| #define | XTIMER_DEV (TIMER_DEV(0)) |
| #define | XTIMER_HZ (250000UL) |
| #define | XTIMER_WIDTH (16) |
| #define | XTIMER_CHAN (0) |
Board controller configuration | |
Define the GPIO pin to enable the BC, to allow serial communication via the USB port. | |
| #define | BC_PIN GPIO_PIN(PA, 9) |
Push button pin definitions | |
| #define | PB0_PIN GPIO_PIN(PC, 8) |
| #define | PB1_PIN GPIO_PIN(PC, 9) |
LED pin definitions | |
| #define | LED0_PIN GPIO_PIN(PC, 10) |
| #define | LED1_PIN GPIO_PIN(PC, 11) |
Macros for controlling the on-board LEDs | |
| #define | LED0_ON gpio_set(LED0_PIN) |
| #define | LED0_OFF gpio_clear(LED0_PIN) |
| #define | LED0_TOGGLE gpio_toggle(LED0_PIN) |
| #define | LED1_ON gpio_set(LED1_PIN) |
| #define | LED1_OFF gpio_clear(LED1_PIN) |
| #define | LED1_TOGGLE gpio_toggle(LED1_PIN) |
Core temperature sensor configuration | |
Connection to the on-chip temperature sensor. | |
| #define | CORETEMP_ADC ADC_LINE(0) |
Display configuration | |
Connection to the on-board Sharp Memory LCD (LS013B7DH03). | |
| #define | DISP_SPI SPI_DEV(0) |
| #define | DISP_COM_PIN GPIO_PIN(PE, 10) |
| #define | DISP_CS_PIN GPIO_PIN(PE, 11) |
| #define | DISP_SELECT_PIN GPIO_PIN(PA, 8) |
| #define | DISP_POWER_PIN GPIO_PIN(PA, 10) |
| #define LED0_OFF gpio_clear(LED0_PIN) |
| #define LED0_TOGGLE gpio_toggle(LED0_PIN) |
| #define LED1_OFF gpio_clear(LED1_PIN) |
| #define LED1_TOGGLE gpio_toggle(LED1_PIN) |
1.12.0