SODAQ ONE

Caution

This page is automatically generated from RIOT doxygen documentation. If you find any issues or have suggestions for improvement, please report them on Github.

View Doxygen Documentation View this board's documentation as generated by Doxygen.

View on GitHub View this board's source code on GitHub.

Tip

When using this board with RIOT, set the BOARD variable to sodaq-one in your Makefile. If you follow the standard RIOT project structure, your Makefile should look like this:

./Makefile

# name of your application
APPLICATION = hello-world

# Change this to your board if you want to build for a different board
BOARD ?= sodaq-one

# This has to be the absolute path to the RIOT base directory:
RIOTBASE ?= $(CURDIR)/RIOT

include $(RIOTBASE)/Makefile.include

Support for the SODAQ ONE board

General information

General information about this board can be found on the SODAQ support website.

Flash the board

Use BOARD=sodaq-one with the make command.
Example with hello-world application:

    make BOARD=sodaq-one -C examples/basic/hello-world flash

Note: If the application crashes, automatic reflashing via USB, as explained above won’t be possible. In this case, the board must be set in bootloader mode by double tapping the reset button before running the flash command.

Accessing STDIO via UART

STDIO of RIOT is directly available over the USB port.

The TERM_DELAY environment variable can be used to add a delay (in second) before opening the serial terminal. The default value is 2s which should be enough in most of the situation.