STM32 Nucleo-L476RG

Caution

This page is automatically generated from RIOT doxygen documentation. If you find any issues or have suggestions for improvement, please report them on Github.

View Doxygen Documentation View this board's documentation as generated by Doxygen.

View on GitHub View this board's source code on GitHub.

Tip

When using this board with RIOT, set the BOARD variable to nucleo-l476rg in your Makefile. If you follow the standard RIOT project structure, your Makefile should look like this:

./Makefile

# name of your application
APPLICATION = hello-world

# Change this to your board if you want to build for a different board
BOARD ?= nucleo-l476rg

# This has to be the absolute path to the RIOT base directory:
RIOTBASE ?= $(CURDIR)/RIOT

include $(RIOTBASE)/Makefile.include

Support for the STM32 Nucleo-L476RG

Overview

The Nucleo-L476RG is a board from ST’s Nucleo family supporting ARM Cortex-M4 STM32L476RG microcontroller with 128KiB of RAM and 1MiB of Flash.

You can find general information about the Nucleo64 boards on the boards_common_nucleo64 page.

Pinout

MCU

MCU	STM32L476RG
Family	ARM Cortex-M4F
Vendor	ST Microelectronics
RAM	128KiB
Flash	1MiB
Frequency	up to 80MHz
FPU	yes
Timers	16 (2x watchdog, 1 SysTick, 6x 16-bit, 2x 32-bit [TIM2])
ADCs	3x 12-bit (up to 16 channels)
UARTs	6 (three USARTs, two UARTs and one Low-Power UART)
SPIs	3
I2Cs	3
RTC	1
CAN	1
Vcc	1.71 V - 3.6V
Datasheet	Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Flashing the Board

A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-L476RG is nucleo-l476rg.