MSB-430H

View Doxygen Documentation View this board's documentation as generated by Doxygen.

View on GitHub View this board's source code on GitHub.

When using this board with RIOT, set the BOARD variable to msb-430h in your Makefile. If you follow the standard RIOT project structure, your Makefile should look like this:

# name of your application
APPLICATION = hello-world

# Change this to your board if you want to build for a different board
BOARD ?= msb-430h

# This has to be the absolute path to the RIOT base directory:
RIOTBASE ?= $(CURDIR)/RIOT

include $(RIOTBASE)/Makefile.include

Support for the ScatterWeb MSB-430H board

Hardware

ScatterWeb MSB-430H

MCU

MCU	TI MSP430F1612
Family	MSP430
Vendor	Texas Instruments
Package	64 QFN
RAM	5KiB
Flash	55KiB
Frequency	8MHz
FPU	no
Timers	2 (2x 16bit)
ADCs	1x 8 channel 12-bit
UARTs	2
SPIs	2
I2Cs	1
Vcc	2.0V - 3.6V
Datasheet / Reference Manual	Datasheet
User Guide	User Guide

Radio

RF Chip	Texas Instruments® CC1100
Frequency Band	300-348MHz, 400-464 MHz, and 800-928 MHz
Standard compliance	DASH7 compliant
Receive Sensitivity	-94dBm typ
Transfer Rate	500kBaud
RF Power	-30dBm ~ 10dBm
Current Draw	RX: 14.4mA TX: 16.9mA Sleep mode: 400nA
RF Power Supply	2.1V ~ 3.6V
Antenna	Dipole Antenna / PCB Antenna
Datasheet	Datasheet

Flashing RIOT

Flashing RIOT on the MSB-430H is quite straight forward, just connect your board using a JTAG adapter (either the original one from TI or an Olimex version) to your host computer and type:

make flash

This should take care of everything!

Using the shell

The shell is using the UART interface of the MSB-430H at 115200 baud. You need a 3.3V TTL serial cable. For USB connections you could use a FTDI connector.

More information

FU Berlin info page on the MSB-430H