board.h

Go to the documentation of this file.

/*
 * Copyright (C) 2018 Freie Universität Berlin
 *
 * This file is subject to the terms and conditions of the GNU Lesser
 * General Public License v2.1. See the file LICENSE in the top level
 * directory for more details.
 */
 
#ifndef BOARD_H
#define BOARD_H
 
#include "cpu.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
#define LED0_PIN            GPIO_PIN(0, 17)
#define LED1_PIN            GPIO_PIN(0, 19)
 
/* as a shortcut, we include the two CS pins into the LED_MASK, this will make
 * sure both pins are initialized as output and set during board initialization.
 * This is needed so that the BMX280 and LIS2DH12 device drivers do not
 * interfere... */
#define CS_PIN_MASK         ((1 << 3) | (1 << 8))
 
#define LED_PORT            NRF_P0
#define LED0_MASK           (1 << 17)
#define LED1_MASK           (1 << 19)
 
/* mask used in the common board.c file to initialize and set the given pins */
#define LED_MASK            (LED0_MASK | LED1_MASK | CS_PIN_MASK)
 
#define LED0_ON             (LED_PORT->OUTCLR = LED0_MASK)
#define LED0_OFF            (LED_PORT->OUTSET = LED0_MASK)
#define LED0_TOGGLE         (LED_PORT->OUT   ^= LED0_MASK)
 
#define LED1_ON             (LED_PORT->OUTCLR = LED1_MASK)
#define LED1_OFF            (LED_PORT->OUTSET = LED1_MASK)
#define LED1_TOGGLE         (LED_PORT->OUT   ^= LED1_MASK)
#define BTN0_PIN            GPIO_PIN(0, 13)
#define BTN0_MODE           GPIO_IN_PU
#define BMX280_PARAM_CS     GPIO_PIN(0, 3)
#define LIS2DH12_PARAM_CS       GPIO_PIN(0, 8)
#define LIS2DH12_PARAM_INT_PIN1 GPIO_PIN(0, 2)
#define LIS2DH12_PARAM_INT_PIN2 GPIO_PIN(0, 6)
#ifdef __cplusplus
}
#endif
 
#endif /* BOARD_H */