board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2019 Gunar Schorcht
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once

 
#include <stdint.h>


#define BTN0_PIN        GPIO0

#define BTN0_MODE       GPIO_IN

#ifndef BTN0_INT_FLANK
#define BTN0_INT_FLANK  GPIO_FALLING
#endif

#define BUTTON0_PIN     BTN0_PIN


#define LED0_PIN        GPIO25
#define LED0_ACTIVE     (1)     

#define SX127X_PARAM_SPI                (SPI_DEV(0))
#define SX127X_PARAM_SPI_NSS            GPIO18
#define SX127X_PARAM_RESET              GPIO14
#define SX127X_PARAM_DIO0               GPIO26
#define SX127X_PARAM_DIO1               GPIO_UNDEF /* GPIO35 has no pulldown, leads to init error */
#define SX127X_PARAM_DIO2               GPIO_UNDEF /* GPIO34 has no pulldown, leads to init error */
#define SX127X_PARAM_DIO3               GPIO_UNDEF
#define SX127X_PARAM_DIO_MULTI          GPIO_UNDEF
 
/* include common board definitions as last step */
#include "board_common.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
#ifdef __cplusplus
} /* end extern "C" */
#endif