periph_conf.h

Go to the documentation of this file.

/*
 * Copyright (C) 2018 Gunar Schorcht
 *
 * This file is subject to the terms and conditions of the GNU Lesser
 * General Public License v2.1. See the file LICENSE in the top level
 * directory for more details.
 */
 
#ifndef PERIPH_CONF_H
#define PERIPH_CONF_H
 
#include <stdint.h>
 
#ifdef __cplusplus
 extern "C" {
#endif
 
#ifndef ADC_GPIOS
#define ADC_GPIOS   { GPIO34, GPIO35, GPIO36, GPIO39 }
#endif
 
#ifndef DAC_GPIOS
#define DAC_GPIOS   { GPIO25 }
#endif
#ifndef I2C0_SPEED
#define I2C0_SPEED  I2C_SPEED_FAST  
#endif
#ifndef I2C0_SCL
#define I2C0_SCL    GPIO22          
#endif
#ifndef I2C0_SDA
#define I2C0_SDA    GPIO21          
#endif
#ifndef PWM0_GPIOS
#define PWM0_GPIOS { GPIO2, GPIO0, GPIO4, GPIO15 }
#endif
 
#ifndef SPI0_CTRL
#define SPI0_CTRL   VSPI    
#endif
#ifndef SPI0_SCK
#define SPI0_SCK    GPIO18  
#endif
#ifndef SPI0_MISO
#define SPI0_MISO   GPIO19  
#endif
#ifndef SPI0_MOSI
#define SPI0_MOSI   GPIO23  
#endif
#ifndef SPI0_CS0
#define SPI0_CS0    GPIO5   
#endif
#define UART0_TXD   GPIO1  
#define UART0_RXD   GPIO3  
#if CONFIG_FLASHMODE_DOUT || CONFIG_FLASHMODE_DIO || DOXYGEN
#ifndef UART1_TXD
#define UART1_TXD   GPIO10  
#endif
#ifndef UART1_RXD
#define UART1_RXD   GPIO9   
#endif
#else
#warning Configuration problem: Flash mode is qio or qout, \
         GPIO9 and GPIO10 are not available for UART1 as configured
#endif
#ifdef __cplusplus
} /* end extern "C" */
#endif
 
/* include common board definitions as last step */
#include "periph_conf_common.h"
 
#endif /* PERIPH_CONF_H */