Loading...
Searching...
No Matches
gpio_params.h
1#ifndef GPIO_PARAMS_H
2#define GPIO_PARAMS_H
3
4#include "board.h"
5#include "saul/periph.h"
6
7#ifdef __cplusplus
8extern "C"
9{
10#endif
11
16static const saul_gpio_params_t saul_gpio_params[] =
17 {
18 {
19 .name = "LED1",
20 .pin = LED0_PIN,
21 .mode = GPIO_OUT,
22 .flags = SAUL_GPIO_INIT_SET,
23 },
24 {
25 .name = "LED2",
26 .pin = LED1_PIN,
27 .mode = GPIO_OUT,
28 .flags = SAUL_GPIO_INIT_SET,
29 },
30 {
31 .name = "LED3",
32 .pin = LED2_PIN,
33 .mode = GPIO_OUT,
34 .flags = SAUL_GPIO_INIT_SET,
35 },
36 {
37 .name = "LED4",
38 .pin = LED3_PIN,
39 .mode = GPIO_OUT,
40 .flags = SAUL_GPIO_INIT_SET,
41 },
42 {
43 .name = "BTN USER",
44 .pin = BTN0_PIN,
45 .mode = BTN0_MODE,
46 },
47};
48
49#ifdef __cplusplus
50}
51#endif
52
53#endif /* GPIO_PARAMS_H */
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition gpio_params.h:33
LED1_PIN
#define LED1_PIN
TX LED yellow.
Definition board.h:34
LED2_PIN
#define LED2_PIN
RX LED yellow.
Definition board.h:35
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition periph_cpu.h:165
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INIT_SET
@ SAUL_GPIO_INIT_SET
set pin active after init
Definition periph.h:45
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition periph.h:51
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition periph.h:52
board.h
Board specific definitions for the Zigduino board.