Loading...
Searching...
No Matches
gpio_params.h
Go to the documentation of this file.
1/*
2 * Copyright (C) 2018 HAW Hamburg
3 *
4 * This file is subject to the terms and conditions of the GNU Lesser
5 * General Public License v2.1. See the file LICENSE in the top level
6 * directory for more details.
7 */
8
19#ifndef GPIO_PARAMS_H
20#define GPIO_PARAMS_H
21
22#include "board.h"
23#include "saul/periph.h"
24
25#ifdef __cplusplus
26extern "C" {
27#endif
28
33{
34 {
35 .name = "LED Builtin",
36 .pin = LED0_PIN,
37 .mode = GPIO_OUT
38 },
39 {
40 .name = "LED Red",
41 .pin = LED1_PIN,
42 .mode = GPIO_OUT,
44 },
45 {
46 .name = "LED Green",
47 .pin = LED2_PIN,
48 .mode = GPIO_OUT,
50 },
51 {
52 .name = "LED Blue",
53 .pin = LED3_PIN,
54 .mode = GPIO_OUT,
56 }
57};
58
59#ifdef __cplusplus
60}
61#endif
62
63#endif /* GPIO_PARAMS_H */
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition gpio_params.h:33
#define LED1_PIN
TX LED yellow.
Definition board.h:34
#define LED2_PIN
RX LED yellow.
Definition board.h:35
@ GPIO_OUT
select GPIO MASK as output
Definition periph_cpu.h:165
Parameter definitions for mapping peripherals directly to SAUL.
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition periph.h:44
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition periph.h:43
Direct mapped GPIO configuration values.
Definition periph.h:51
const char * name
name of the device connected to this pin
Definition periph.h:52
Board specific definitions for the Zigduino board.