The friendly Operating System for the Internet of Things
iotlab-common/include/board_common.h File Reference

Board specific definitions for the iotlab-m3 board. More...

Detailed Description

#include <stdint.h>
#include "cpu.h"
#include "periph_conf.h"
#include "periph_conf_common.h"
+ Include dependency graph for iotlab-common/include/board_common.h:

Go to the source code of this file.

Macros

Set the default baudrate to 500K for this board
#define UART_STDIO_BAUDRATE   (500000U)
 
Tell the xtimer that we use a 16-bit peripheral timer
#define XTIMER_WIDTH   (16)
 
Define the interface to the AT86RF231 radio

{spi bus, spi speed, cs pin, int pin, reset pin, sleep pin}

#define AT86RF2XX_PARAMS_BOARD
 
#define LED0_PIN   GPIO_PIN(PORT_D, 2)
 LED pin definitions and handlers.
 
#define LED1_PIN   GPIO_PIN(PORT_B, 5)
 
#define LED2_PIN   GPIO_PIN(PORT_C, 10)
 
#define LED0_MASK   (1 << 2)
 
#define LED1_MASK   (1 << 5)
 
#define LED2_MASK   (1 << 10)
 
#define LED0_ON   (GPIOD->ODR &= ~LED0_MASK)
 
#define LED0_OFF   (GPIOD->ODR |= LED0_MASK)
 
#define LED0_TOGGLE   (GPIOD->ODR ^= LED0_MASK)
 
#define LED1_ON   (GPIOB->ODR &= ~LED1_MASK)
 
#define LED1_OFF   (GPIOB->ODR |= LED1_MASK)
 
#define LED1_TOGGLE   (GPIOB->ODR ^= LED1_MASK)
 
#define LED2_ON   (GPIOC->ODR &= ~LED2_MASK)
 
#define LED2_OFF   (GPIOC->ODR |= LED2_MASK)
 
#define LED2_TOGGLE   (GPIOC->ODR ^= LED2_MASK)
 
xtimer tuning values
#define XTIMER_OVERHEAD   6
 
#define XTIMER_SHOOT_EARLY   3
 

Functions

void board_init (void)
 Initialize board specific hardware, including clock, LEDs and std-IO.